We work respecting the quality of all the processes, to press, heating and cutting metal. In the axial type hot forging press, heats up to 1200 degrees cut steel material, it is molded between closed with 3 processes, mainly, press, roughing and finishing and trimming burr of the around going giving the finish of the piece.
In Kawada, we put in perspective the efficiency of processing department of the following processes of our company, considering the space and inclinations to be able remove the piece, 4pieces are manufactured in 1 minute, 3 hand machines press1600t and 3 machines press 2500 t.

Precision without errors by automatic line The axial type hot forging press automatic, heats up to 1200 degrees cut steel material, molded in closed with 4 processes mainly, press, drilling, roughing and finishing and trimming burr of the around going giving the finish of the piece.
Kawada, considering the space and inclinations to be able remove the piece,4 pieces are manufactured in 1 minute.
Considering the consumption of forging mold, carrying out verification of status of the mold to be able to extend the life of the mold, adjusting the state and change, we change the conditions going giving the finish of the piece.

To achieve high performance and low cost, we have a few machines AMP Kawada has 3 high speed hot forging press machines cross-type (AMP: Automatic Multistage Press).
It is a machine created by the company Hatebur, which performed the cutting of the bar material, heating, formation and piercing, and there are only 20 forging machines adopted.
AMP shows its efficiency in works of side hits and performs to high speed forging of round parts such as gear mission and others.